Asus ROG STRIX XG259QN Series 사용자 설명서 - 페이지 20

{카테고리_이름} Asus ROG STRIX XG259QN Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Asus ROG STRIX XG259QN Series 32 페이지. Gaming monitor

페이지 인쇄
Asus ROG STRIX XG259QN Series 사용자 설명서
3.1.2

OSD function introduction

1.
Gaming
•
Overclocking:
*
*
Overclocking may cause screen flickering. To reduce such effects, disconnect
the DisplayPort cable and use the monitor OSD menu to try again with a safer
Max. Refresh rate.
•
Variable OD: Improves the gray level response time of the LCD panel.
•
Variable Refresh Rate: Allows an Variable Refresh Rate supported* graphics
source to dynamically adjust display refresh rate based on typical content frame
rates for power efficient, virtually stutter free and low-latency display update.
•
•
•
•
•
ELMB/ELMB SYNC: ELMB can only be activated when Variable Refresh Rate
is Off and the refresh rate is 120Hz, 144Hz, 240Hz, 360Hz (DisplayPort only) or
380Hz (DisplayPort only). ELMB SYNC can be activated when Variable Refresh
Rate is On. This function eliminates screen tearing, reduces ghosting and motion
blur when playing games.
ELMB SYNC can only be activated when the refresh rate is greater than (and
not equal to) 60Hz for DisplayPort.
3-2
ROG STRIX XG259QN
1920x1080
380Hz
Overclocking
Gaming
Variable OD
Variable Refresh Rate
Image
ELMB/ELMB SYNC
GamePlus
Color
GameVisual
Shadow Boost
Input Select
MyFavorite
Volume
50
ON: This function allows you to adjust the refresh rate.
Max Refresh Rate: Allows you to select a maximum refresh rate of 380Hz
(Only for DisplayPort input). After selecting, press the
activate the setting.
Aspect Control is not available when this function is activated.
*Variable Refresh Rate can only be activated within 48Hz~240Hz for
HDMI, 60Hz~380Hz for DisplayPort.
This function is only available when DisplayPort Stream is DisplayPort
1.2 or DisplayPort 1.4.
*For supported GPUs, minimum PC system and driver requirements,
please contact the GPU manufactures.
GameVisual
Input Select
Racing Mode
DisplayPort
10
Back
HDR
OFF
Enter
Exit
(
)
Chapter 3: General Instructions
button to