Dahl VARIODOCK 유지 관리 매뉴얼 - 페이지 16
{카테고리_이름} Dahl VARIODOCK에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dahl VARIODOCK 19 페이지.
Installation of universal fitting in floor pocket and floor rail with airline hole pattern
Make sure that the floor pocket or floor rail is free of small stones or other dirt. If
necessary, clean prior to installation of the universal fitting. If the floor pocket or
the floor rail is not free of dirt, there is a risk that the fitting cannot be installed or
that it will not be fitted correctly.
A
Warning
In countries where legislation demands meeting EU-Regu lation 2018/858, Annex II,
Part III, Appendix 3 relating to vehicles fitted for wheelchairs, a fitting kit MUST be
used, which has been tested in the position and the specific vehicle the wheelchair
will be used in, for fitting the docking system and safety belts for the wheelchair
user.
Please enquire with regard to the current range of vehicle specific fitting kits with
corresponding fitting instructions.
30
Maintenance manual, installation and user guide UK
1. Place the universal fitting over the holes.
2. Press downwards on the universal fitting so that the spring-action locking bolt
moves upwards. Whilst the fitting is being pressed downwards, push the fitting
backwards or forwards until the spring-action locking bolt slides down into one
of the holes.
3. A click should be heard when the locking bolt hits the bottom of the hole.
B
If a vehicle specific fitting instruction exists, it must be requested from Dahl
Engineering, and followed when fitting safety belts, floor pockets, floor rails and
docking station.
The following fitting examples for fitting the Dahl VarioDock can only be used in
countries where no legal requirements to tests of docking system in the specific
vehicle and mounting position are to be found.
We always recommend using a fitting kit which has been tested in the specific
vehicle and which meets EU regulation 2018/858.
Installation examples of floor pocket
Min 10 mm plywood
Art. no. 501898
Driving direction
C
Art. no. 501897
Driving direction
▲ = Preferred way of mounting
■ = Optional way of mounting
81
▲
Driving direction
(
)
▲
(
)
Driving direction
Driving direction
(
)
Dahl VarioDock™
31