DOTWORKZ COOLDOM ST-CD-24V 설치 매뉴얼 - 페이지 9
{카테고리_이름} DOTWORKZ COOLDOM ST-CD-24V에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DOTWORKZ COOLDOM ST-CD-24V 17 페이지. S-type cooldome enclosure
페이지 인쇄Mounting S-Type Enclosure
Attaching Enclosure to Dotworkz Strong-Arm: Provided on S-Type equipment for Ring of Fire™ & COOLDOME models™
Locate & assemble four ¼"-20 x 5/8" hex bolts with lock washers provided in hardware pack of Strong-Arm.
Turn over S-Type housing to show threaded base inserts, pre-install four ¼" diameter bolts in Tilt head of Strong-Arm. Note orientation of tilt locking
screws toward rear of S-Type. Firmly tighten all four bolts to secure tilt mount to S-Type housing.
Wall Mounting
Mounting to wall requires four user supplied fasteners. Mark pilot holes for four (4) mount holes either by marking with base, or using template guide
on back page of this manual. Drill pilot holes and bolt arm to wall securely. Four holes on S-Type arm will accommodate up to 5/16" diameter bolts.
Always assure there is strong backing material & the proper strong & secure to anchoring into aggregate material of wall is made.
Re-assemble Housing with Pan-Tilt onto Mount Arm by securing two side screws for pan adjustment. Secure & tighten both screws evenly, also adjust
& tighten tilt screws into desired final position. Be sure all fasteners are evenly and securely tightened. After completing wiring, close access door to
wire feed on mount, complete internal wire & cable installation, and close and seal housing top & wire feed seals.
Wiring Notes:
Always consult and follow all local and applicable electrical codes to install and service housing. Always shut off power before
installation and follow all applicable safety practices and guidelines. Only qualified electrical technicians should prepare & service wiring. Fully read &
understand all installation guidelines before attempting to install wiring & housing.
Site wiring can be installed behind, or installed to side of base of the S-Type Strong-Arm. Main body of this Arm has room for flush electric
box, or cable feed thru wall to be mounted behind mounting base. Prepare wiring before installation of this housing mount, allowing strong backing
material to secure Strong-Arm mount. Hole on side of mount arm and on bottom of S-Type housing are clearance holes that will accept ½" NPT
fittings or PG13 equivalent.
Wire feed can be directly into hollow of Arm, with room for wire management within Arm body. Hole on side of mount arm, and feeds on
bottom of S-Type housing are clearance holes that will accept ½" NPT fittings or PG13 equivalent. A plug is provided with Arm hardware if this feed
hole is not used. Some customers will choose to provide & use liquid tight fittings & conduit to make the connection arm feed and S-Type enclosure.
Always create a drip loop between all external conduit or cable connections between fittings and S-Type Housing. All cable feeds must be
sealed before S-Type housing is put into service to provide dry, electrically safe, and effective product performance.