DOTWORKZ COOLDOME ST-CD 설치 매뉴얼 - 페이지 16

{카테고리_이름} DOTWORKZ COOLDOME ST-CD에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DOTWORKZ COOLDOME ST-CD 17 페이지. S-type cooldome enclosure

S-Type COOLDOME Internal Wiring

S-Type COOLDOME

Before camera &

Power install

Pull power and Data cables into housing thru Cable Gland strain relief seal ports near rear of S-Type enclosure. Strip

back wires on Low Voltage 12VDC power cable brought into enclosure, observing DC polarity.

With a Volt Meter, Check voltage on wires pulled in from power supply, before attaching wires to assure Low Voltage

12 VDC input wires and proper polarity.

Hook up +12VDC to red terminal, and (-) DC ground wire to black terminal. Tighten firmly with small flat blade

screwdriver.

Hook up user supplied data cable to camera. Install power cable to camera. (See camera power page if your

camera power cable is not compatible with the power cable shown above)

Be sure to tighten cable gland seals to assure a weather tight seal.

Gently but firmly tighten four enclosure cover screws to fully seal

enclosure.

S-Type COOLDOME

after power & camera

installation- typical