Dahle 848 블레이드 설치 지침 - 페이지 2

{카테고리_이름} Dahle 848에 대한 블레이드 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dahle 848 2 페이지. Ream cutter
Dahle 848에 대해서도 마찬가지입니다: 사용 설명서 (14 페이지)

페이지 인쇄

Blade Removal Instructions for the DAHLE 842, 846, and 848 Ream Cutter

Tools You Will Need

•

3 mm hex key

•

4 mm Hex Key*

•

5 mm Hex Key*

•

Blade Carrying Device*

*Included in blade replacement kit

With a 3 mm hex key,

remove the hex screws on

the clear plastic cover to

the left of the cutting blade

(while facing the machine).

Remove the cover.

Remove the four hex

screw on the top of the

clear plastic safety cover

located to the right of the

cutting blade (while facing

the machine).

Remove

the cover.

2. Lift the cutting arm to its

highest position. With a 4

mm hex key, remove the

two screw on the left side

of the blue metal blade

cover.

Once the screws

are removed, lift the cover

and slide it over the top of

the handle.

Lower the cutting arm to its

lowest position.

Locate the

blade and the three hex screws

that hold the blade in place.

Remove the center hex screw

and insert the blade carrying

device (looks like a screwdriver

with threads on the tip) and

tighten. Remove the remaining

two hex screws that hold the

blade in place.

Once the blade is free,

remove it from the cutter

and place it in a safe

container.

5. Lift the blade arm to its highest

position.

Loosen

the

carrying device a few turns. With

b o t h

h an d s ,

gen t ly

downward being careful to keep

fingers clear of the blade. If the

blade does not move, loosen the

blade carrying device a little more,

lower the cutting arm, and again

gently push the blade downward.

blade

p u s h