Double K Industries ChallengAir AIRMAX 사용 설명서 - 페이지 4

{카테고리_이름} Double K Industries ChallengAir AIRMAX에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Double K Industries ChallengAir AIRMAX 4 페이지.

Fig. 1 Side
Brush Assembly
Retainer (Ref # 2)
Motor Part
# 2069
Fig. 3 Top
Down
Brush Assembly
Brush Assembly with
Retainer (Ref # 2)
Metal Body (Ref # 1)
Part #2065
Brush Retainer
Arm must slide into
the Male Terminal.
Male Terminal
7
Fig. 2 Top
Brush Assembly with
Brush Assembly
Metal Body (Ref # 1)
Retainer Screw (Ref # 3)
Brush Assembly
Retainer Screw
(Ref # 3)
Brush
Assembly Tab
(Ref # 4)
BRUSHES: Your CHALLENGAIR AirMax has two brush-type motors. The brushes should be
checked for wear after approximately 500 hours of use. If the carbon brushes are worn shorter
than 1/4 inch, the brushes should be replaced. Brushes may be ordered from Double K
Industries or an Authorized Service Center (you will need 2 sets, 1 set for each motor). Please
be sure to specify that your dryer is an AirMax, as the brushes are slightly different from one
dryer model to another.
To check and/or replace brushes:
1.
Unplug electrical cord from wall outlet.
Disassembly:
2.
Slide off the back cover from the dryer. This is a compression fit and will come off with a
little effort.
3.
Remove all screws on the outside of the dryer that hold the two halves of dryer housing in
place. It may be best to lay the dryer on its side while removing these screws.
4.
Each motor will be sitting in place inside the rubber silicone motor mounts. Removing the
rubber silicone motor mounts from the motor is not necessary to replace brushes.
5.
Disconnect the motor power wires.
6.
Front motor:
a.
Loosen the two brush assembly retainer screws (Fig. 3, Ref # 3) to loosen the
brush assembly retainer (Fig. 3, Ref # 2). Remove the brush assembly (Fig. 3,
Ref # 1) and replace it with a new one. (Note: IMPORTANT - the brush has a
small tab on the bottom that MUST be fitted into the slot on the motor frame for
proper positioning) (Fig. 3, Ref # 4)
b.
After the new brush assembly is seated, tighten the brush assembly retainer
screws.
c.
Repeat steps A-B for the brush on other side of motor.
Rear motor:
a.
Follow steps A-C above, as outlined for the front motor.
Reassembly:
7.
Inspect the motor mounts for cracks or damage -- replace if necessary. Set the motors
back into their original positions in the dryer housing. Each motor mount has slots that
fits over corresponding alignment tabs on the inside of the dryer housing. These slots and
tabs must match up for proper fit and function. (Note: In the event that the motor mount is
removed from the motor, simply replace it by being mindful to align the contours of the
motor mount with corresponding contours on the motor housing.)
8.
Reattach the screws around the outside of the dryer making sure the two halves are
matching up.
9.
After the two halves of the dryer housing have been put together, replace motor filter on
back motor and push the burgundy back cover back onto the rear of the dryer. Replace
exterior filter on to burgundy back cover. Always make sure all filters are in place before
operating dryer.
8