Dahle DAHLE 450 Series 운영 매뉴얼 - 페이지 4
{카테고리_이름} Dahle DAHLE 450 Series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dahle DAHLE 450 Series 7 페이지. Hopper feed shredder
Dahle DAHLE 450 Series에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지)
페이지 인쇄
CARING FOR YOUR SHREDDER
Clean covers with a clean dry cloth. Do not use water or solvents. Make sure
you disconnect your shredder from its power source before cleaning.
Paper shredders, like all mechanical equipment, need proper maintenance to
ensure efficient operation.
important to offset the friction generated within the cutting head. Frequency of
lubrication will vary depending on the shred size and the amount of usage. A
strip-cut shredder receiving light use (1 – 2 hours per week) will require
lubrication only once or twice a month, while the same machine used 1 – 2
hours per day will require lubrication weekly. A cross-cut shredder should be
lubricated every ½ hour of shredding time to maintain maximum capacity and
efficiency.
The procedure for lubricating your shredder is simple, and can be performed
by any operator. The oil is packaged in a squeeze bottle and is applied
directly to the cutting blades through the feed opening (3). Run a fine stream
of lubricant from one side of the feed opening to the other. Run the shredder
in REVERSE for a few seconds to help distribute the lubricant evenly. You
can now continue shredding as usual.
DAHLE Shredder Oil is the only lubricant you should use in your paper
shredder. It has been specially formulated so as not to leave any residue that
could attract dust and clog the shredding mechanism. You can order DAHLE
Shredder Oil (item # 740) from your local dealer.
Repairs on your paper shredder should only be performed by qualified
technicians.
If you need service, contact your local dealer, or you can
contact DAHLE USA Customer Service between 8:30 am and 5:00 pm EST at
(800) 995-1379.
BEFORE YOU CALL FOR SERVICE
SYMPTOM POSSIBLE CAUSES
No Power
Low capacity
IF ANY OTHER PROBLEMS OCCUR, CALL YOUR AUTHORIZED DAHLE SERVICE DEALER
Periodic lubrication of the cutting blades is
Unit not unlocked
Unit unplugged
Outlet dead
Door not fully closed
Shred Bag full
Cutting blades dry
SOLUTION
Unlock Safety Button
and press reset
Connect to outlet
Reset circuit breaker
Close Door
Change Shred Bag
Lubricate cutting blades
according to instruction.
1-800-658-8788 - www.abcoffice.com