Electralog DF2006 사용자 설명서 - 페이지 11

{카테고리_이름} Electralog DF2006에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electralog DF2006 15 페이지.

reMOTe OPeraTIOn

The Fireplace is supplied with an integrated on/off remote control

Note: Ensure that the fireplace 3 position switch is set to the

Remote Control setting. (Up position)

To operate, push the ON button to turn fireplace on, push the OFF button

to turn the fireplace off.

To replace the battery:

1. Slide battery cover open on the hand held transmitter. (FIGURE 9)

2. Correctly install one 12 volt (A23) battery in the battery holder.

3. Close the battery cover.

On Button

FIGURE 9

reMOTe COnTrOl InITIalIZaTIOn

In the event that your remote control ceases to operate your fireplace,

follow these steps to reinitialize the hand held transmitter and the remote

control receiver in the fireplace:

1. Place the MAIN ON/OFF SWITCH (FIGURE 8A) in the OFF ("o")

position.

2. Wait a minimum of 5 seconds and then place the MAIN ON/OFF

SwiTCh in the Remote Control position.

3. Within 10 seconds of changing the switch position, press the ON

button located on the remote control transmitter (FIGURE 9). This

will synchronize the remote control transmitter and the fireplace receiver.

nOTe: You will have only 10 seconds to perform this last step. Failure

to do so will result in these steps needing to be followed again.

If you are still experiencing issues with your remote control, contact

Electralog Customer Service at 1-888-346-7539.

www.sylvane.com 1-800-934-9194

Off Button

Battery

Cover