Electralog ELECTRALOG DFP15-1132NG 소유자 매뉴얼 - 페이지 9
{카테고리_이름} Electralog ELECTRALOG DFP15-1132NG에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electralog ELECTRALOG DFP15-1132NG 13 페이지.
페이지 인쇄Maintenance
WARNINg: Disconnect
power before attempting any
maintenance or cleaning to
reduce the risk of fire, electric
shock or damage to persons.
WARNINg: Any other
maintenance should be
performed by an authorized
service representative.
Bulb Replacement
Allow at least five (5) minutes for
light bulbs and heater to cool off
before touching bulbs to avoid
accidental burning of skin.
The bulb is located behind the
back panel. To gain access to
the bulb, the screws indicated in
Figure 3 (4 screws) which secure
the back panel, must be removed.
•
Remove and slide out panel
as indicated on Figure 3.
•
Remove the defective lamp
by unscrewing it as shown in
Figure 4.
•
Replace with a 60W
E12 clear chandelier or
candelabra. Take care not to
over-tighten the bulb.
•
Refit the back panel and
secure with the screws.
Figure 3
Figure 4
!
NOTE: When the unit is not
in use, unplug the cord and
neatly coil the cord and set it
beside the unit.
9