Electralog Fireplace Compact 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Electralog Fireplace Compact에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electralog Fireplace Compact 15 페이지. 20" compact
Electralog Fireplace Compact에 대해서도 마찬가지입니다: 소유자 매뉴얼 (15 페이지), 소유자 매뉴얼 (15 페이지)

페이지 인쇄

1. Operation

Installation

WARNING: Ensure the power

cord is not installed so that it is

pinched or against a sharp edge

and ensure that the power cord is

stored or secured to avoid tripping

or snagging to reduce the risk

of fire, electric shock or injury to

persons.

WARNING: Construction

and electrical outlet wiring must

comply with local building codes

and other applicable regulations

to reduce the risk of fire, electric

shock and injury to persons.

WARNING: Do not attempt

to wire your own new outlets or

circuits. To reduce the risk of fire,

electric shock or injury to persons,

always use a licensed electrician.

Figure 1

Hardware

Main Body

Rear Support

Mantel Top

WARNING: To reduce the risk

of fire, do not store or use gaso-

line or other flammable vapors or

liquids in the vicinity of the heater.

CAUTION:

risk of fire, keep electrical cords,

drapery, furnishings, and other

combustibles at least 3 ft (0.9 m)

from the front of the heater.

NOTE: A 15 Amp, 120 Volt

alternating current (VAC) circuit

is required. A dedicated circuit

is preferred but not essential in

all cases. A dedicated circuit will

be required if, after installation,

the circuit breaker trips or fuse

blows on a regular basis when the

heater is operating. Additional

appliances on the same circuit

may exceed the current rating of

the circuit breaker.

(No assembly required for the

flat wall mantel)

Corner Mantel Assembly

1. Assemble the top of the man-

tel to the rear support using

the supplied hardware.

2. Using the supplied hardware

assemble the top and rear

support assembly to the main

fireplace body (Figure 1).

High temperature,