Doug Fleenor Design Preset 10 Architectural 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Doug Fleenor Design Preset 10 Architectural에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Doug Fleenor Design Preset 10 Architectural 8 페이지.

PRESET 10 ARCHITECTURAL – SETUP

FACEPLATE CONFIGURATION

Each Preset 10 Architectural has four jumpers, JP1 through JP4, which select different modes of

operation. The factory default is to have all jumpers installed.

JP1

When this jumper is installed on the MAIN faceplate, recording of presets is enabled. When

removed, the TIME and RECORD buttons are disabled. The position of JP1 on a REMOTE

faceplate has no effect.

JP2

When this jumper is installed, the faceplate takes on the MAIN duty. The MAIN faceplate is

responsible for transmitting and receiving DMX512, storing presets, and communicating with

REMOTE faceplates. When removed, the faceplate takes on the REMOTE duty. A REMOTE

faceplate communicates button presses and mimics the state of the LEDs on the master

faceplate.

JP3

When this jumper is installed, the Preset 10 operates as an architectural preset station. When this

jumper is removed, the Preset 10 operates as a console backup/portable station. This jumper

modifies the personality of the Preset 10 software.

JP4

When this jumper is installed, it enables SINGLE STATION MODE. In this mode, the faceplate

will not send any "alternate start code" packets. When this jumper is removed, it enables MULTI

STATION MODE. This allows the alternate start code packets required for main/remote station

operation. If your system contains only one Preset 10, there is no need to remove the jumper.

MAIN AND REMOTE SELECTION

In a system with more than one faceplate, only one MAIN is allowed. To modify a faceplate to become a

MAIN which can support REMOTE stations, the shunt located at JP2 should be installed and the shunt at

JP4 should be removed. For safe keeping, place the shunt over only one of the pins at JP4.

To modify a faceplate to become a REMOTE station, the shunts located at JP2 and JP4 should be

removed. For safe keeping, place the shunt over only one of the pins at JP2 and JP4.

Page 5 of 8