Baumer 11205779 운영 매뉴얼 - 페이지 8

{카테고리_이름} Baumer 11205779에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer 11205779 32 페이지. Off-highway distance radar sensor

Manual R600V.DAH5 (EN)

Integration Guidance

CAUTION

Installation, mounting and adjustment of this product must only be

executed by skilled and authorized personnel.

2.1.1.

The sensor shall be mounted with its centre axis approximately perpendicular to the target.

The distance output is relative to the tip of the lens. A blind range of 300mm must be con-

sidered. No measurement is possible within the blind range of the sensor. For applications

where accuracy is to be optimised, a flat metal surface (e.g. a 100 x 100mm metal plate) is

recommended. If the target surface is not mounted perpendicular to the sensor centre axis

the received signal gets weaker. From experience a good value of angular tolerance for a

flat target is less than 2°. Corner cubes are not sensitive to angular tolerances and may be

the more robust choice for situations in which accuracy need not be optimized. To ensure

proper detection over the full sensing range it is recommend aligning the longitudinal axes of

sensor and reflector as shown below. Aligning the axes is especially important to improve

the signal at short distances (below 0.5m) when using a corner cube. For a selection of

available corner cubes, please refer to Tab 15.

The target material thickness (both flat metal plate and corner cube) must be more than

0.5mm and preferably metal. Coatings on the target may affect the reflectance properties.

Non-metal targets may work as well, but sufficient reflectance at radar wavelengths is es-

sential. The reflectance depends on the dielectric constant of the material at the radar wave-

length. Sufficient signal must be validated through integration testing.

300mm

blind

range

300mm

blind

range

Page 8 of 32

Centre axis

<20mm

Flat metal plate

(100 x 100mm)

Corner cube

R600V.DAH5_manual_1.5 (EN).docm

Last Update: 03 Jul 20