Doug Fleenor Design E8ANL-DIN-JBOX 구성 매뉴얼 - 페이지 4

{카테고리_이름} Doug Fleenor Design E8ANL-DIN-JBOX에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Doug Fleenor Design E8ANL-DIN-JBOX 12 페이지. 8 channel ethernet to analog interface

Doug Fleenor Design E8ANL-DIN-JBOX 구성 매뉴얼
Connect using STATIC IP
1. To begin setup, plug in the E8ANL-DIN and ensure that the red "POWER" LED
illuminates.
2. Run a CAT5E (or higher) cable from the Ethernet RJ-45 connector to the
Ethernet port of your computer. The computer's Ethernet interface will need an IP
Address set to 10.X.X.X and a Subnet Mask of 255.0.0.0. The X's can be any
number between 1 and 255, but cannot be the same as the IP listed on the
E8ANL-DIN.
3. Open any web browser and type the IP Address listed on the unit into the
address bar. This opens the internal web server of the E8ANL-DIN. Additionally,
Node Discovery may be used with a static IP. The above section describes how
to download Node Discovery.
4. With the browser open, and the correct IP address in the address bar, you will be
brought to a page in the product's built-in webserver to configure your E8ANL-
DIN. The username and password are as follows:
Username: admin
Password: dmx512
Once entered, you can edit your password in the Admin tab.
Page 4 of 12