Baumer GNAMG Series 매뉴얼 - 페이지 38

{카테고리_이름} Baumer GNAMG Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer GNAMG Series 41 페이지. Inclination sensor with canopen interface

6. Terminal assignment and commisisoning

Release both fastening screws of the bus cover.

Carefully loosen the bus cover from the base plate and lift off in the axial direction.

Firmly screw the base plate in place using the fastening holes.

The bus cover must fully rest against the base plate. Any tolerances in mounting the bus cover to the base

plate might affect the absolute slope angle.

Alignment of coordinates (y- / y+ / x- / x+) see following diagram:

Installation position – sensing range 15°, 30° und 60°

Manual_GNAMG_CANopen_EN.doc

21.11.12

The two-dimensional inclination sensor with a sensing range of

15°, 30° and 60° must be mounted with the base plate in

horizontal position, i.e. parallel to the horizontal line.

The inclination sensor may also be installed upside down, i.e.

turned by 180°.

The sensor can be inclined both in lateral (X-axis) and

longitudinal (Y- axis) direction at the same time. For each axis a

separate measured value is provided.

As default parameter the inclination sensor will apply the

selected sensing range to both the X and Y- axis, for example

±15° with the zero passage being precisely in the horizontal line.

38/41

Baumer IVO GmbH & Co. KG

Villingen-Schwenningen, Germany