Asus AAM60BI 빠른 설정 지침 매뉴얼 - 페이지 27

{카테고리_이름} Asus AAM60BI에 대한 빠른 설정 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asus AAM60BI 30 페이지. Asus aam60ev; aam60bi; aam60vi adsl routers

IP = 0.0.0.0 Mask = 0.0.0.0 means all IPs

IP = 192.168.0.0 Mask = 255.255.0.0 all IPs in 192.168.x.x subnet

Protocol

To define the protocol in the rule.

ALL = All IP packet

TCP = TCP packet only

UDP = UDP packet only

ICMP = ICMP packet only

Port

To define the TCP/UDP port number in the rule. Null entry means all ports.

ADD

To add a new defined Rule in the Rule List. It will have effect after this action, but, the new setting will disappear after

ADSL router restarts unless you do SAVE (see below).

DELETE

To delete a pre-defined Rule from the Rule List. The rule number MUST be entered in NO. It will have effect after this

action, but the new setting will disappear after ADSL router restarts.

FLUSH

To remove all Rules in the Rule List. It will have effect after this action, but, the new

setting will disappear after ADSL router restarts.

SAVE

To write the current setting to flash memory. The new settings are available after ADSL

router restarts.

To go to Groups Sub-menu

<HOME>

To return IP Filter Configuration Menu

List of Rules

It displays the current status of all groups.

6.6 Firmware Upgrade

To accomplish a firmware upgrade you will need the Asus Firmware Update software application which is available for the

downloads section of the Solwise site, www.solwise.co.uk/downloads.htm (it is assumed that you are using a standard PC

running Windows 9x or similar). Also, of course, the latest firmware file for upload. Contact Solwise direct or your dealer

for these files. DO NOT GO TO THE ASUS SITE FOR THIS. Solwise have their own, special firmware for UK use. You

cannot get this from the Asus site. To be kept informed of firmware releases as they happen you can also send and email to

the ev firmware mailing list. Just send a blank email (with a valid reply-to address) to [email protected].

Upgrade Procedure:

1.Set up the modem and pc ip address in the same subnet.

2.power on the modem.

3.After the modem has booted up then run the upgrade utility.

4.Enter the router username and password ("adsl" with password "adsl1234" is the default).

5.Click the button "open" to choose the "71146a1.hex"

6.Click the button "upgrade"

- 27 -