COMAC ABILA 52 매뉴얼 - 페이지 18

{카테고리_이름} COMAC ABILA 52에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. COMAC ABILA 52 19 페이지. Scrubber-dryer

1. Check that the cock (1) is open.

2. Check that there is water in the solution tank.

1. Check the brushes wear and replace them if necessary (the brushes must be

replaced when bristles are 15 mm high).

To replace brushes see "BRUSHES DISASSEMBLY" and "BRUSH ASSEMBLY".

2. Use another type of brush rather than the standard brush. We recommend, for

cleaning exceptionally difficult dirt floors, the use of special brushes, supplied on

request and according to your specific needs (see "CHOICE AND USE OF

BRUSHES").

1. Check that the squeegee rubbers are clean

2. Adjust the squeegee inclination (see "SQUEEGEE" in "PREPARING THE MACHINE")

3. Check that the suction pipe is correctly housed in its seat on the recovery tank.

4. Remove the whole suction unit and clean it.

5. Replace the rubbers if worn.

6. Check that the suction motor switch is turn on.

7. Check the wheels regulation.

Check that low-foam detergent is used. Add, if necessary, a small quantity of anti-foam

liquid to recovery tank.

Please remember that more foam is generated when the floor to be cleaned it is not very

dirty. In this case use a more diluted detergent solution.

WORKING CONTROL