Baumer HUBNER BERLIN HOG 10 설치 및 운영 지침 매뉴얼 - 페이지 5

{카테고리_이름} Baumer HUBNER BERLIN HOG 10에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer HUBNER BERLIN HOG 10 36 페이지. Incremental encoder with connecting cable ölfle
Baumer HUBNER BERLIN HOG 10에 대해서도 마찬가지입니다: 설치 및 운영 지침 매뉴얼 (40 페이지), 설치 및 작동 지침 (40 페이지), 설치 및 운영 지침 매뉴얼 (40 페이지), 설치 및 작동 지침 (40 페이지), 설치 및 작동 지침 (40 페이지), 설치 및 작동 지침 (32 페이지), 설치 및 작동 지침 (36 페이지), 설치 및 작동 지침 (36 페이지), 설치 및 작동 지침 (28 페이지)

페이지 인쇄
Baumer HUBNER BERLIN HOG 10 설치 및 운영 지침 매뉴얼
1

General notes

1.1
Symbol guide:
Danger
Warnings of possible danger
General information for attention
Informations to ensure correct product operation
i
Information
Recommendation for product handling
1.2
The incremental encoder HOG 10 (HOG 10 G) is an opto electro nic precision measurement
device which must be handled with care by skilled personnel only.
1.3
The expected operating life of the device depends on the ball bearings, which are equipped with
a permanent lubrication.
1.4
The expected operating life of the earthing brush depends on the electrical current and is
usually consistent with the operating life of the ball bearings.
1.5
The storage temperature range of the device is between -15 °C and +70 °C,
1.6
The operating temperature range of the device is between -40 °C (>3072 pulses per
revolution: -25 °C) and +100 °C (restricted in potentially explosive environments, see
section 2), measured at the housing.
1.7
EU Declaration of Conformity meeting to the European Directives.
1.8
The device is UL approved (not applicable for operation in potentially explosive atmospheres).
1.9
We grant a 2-year warranty in accordance with the regulations of the ZVEI (Central Association
of the German Electrical Industry).
1.10
The encoder may be only opened as described in this instruction. Repair or mainte-
nance work that requires opening the encoder completely must be carried out by the
manufacturer. Alterations of the device are not permitted.
1.11
In the event of queries or subsequent deliveries, the data on the device type label must be
quoted, especially the type designation and the serial number.
1.12
Encoder components are to be disposed of according to the regulations prevailing in the re-
spective country.
i
Warning!
Damaging the seal
MB045T1 - 11145663
on the device invalidates warranty.
Baumer_HOG10-HOG10G-CANNON-T1_II_DE-EN (16A4)
1
General notes
2