Baumer HUBNER BERLIN HOG 11 설치 및 작동 지침 - 페이지 22
{카테고리_이름} Baumer HUBNER BERLIN HOG 11에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer HUBNER BERLIN HOG 11 32 페이지. Incremental encoder (twin encoder) with radial terminal box
Baumer HUBNER BERLIN HOG 11에 대해서도 마찬가지입니다: 설치 및 운영 지침 매뉴얼 (32 페이지), 설치 및 작동 지침 (40 페이지), 설치 및 운영 지침 매뉴얼 (40 페이지), 설치 및 작동 지침 (40 페이지)
페이지 인쇄7
Elektrischer Anschluss / Electrical connection
7.4
Option EMS (Enhanced Monitoring
System): Status LED / Fehlerausgang
Rotblinkend
Signalfolge-, Nullimpuls- oder Impulszahl-
fehler
(Fehlerausgang = HIGH-LOW-Wechsel)
Rot
Ausgangstreiber überlastet
(Fehlerausgang = LOW)
Aus
Versorgungsspannung falsch bzw. nicht
angeschlossen
(Fehlerausgang = LOW)
Grünblinkend
Gerät o.k., drehend
(Fehlerausgang = HIGH)
Grün
Gerät o.k., Stillstand
(Fehlerausgang = HIGH)
Nur bei drehendem Gerät
6)
Only at rotating device
6)
19
6)
500 ms
Blockschaltbild / Block diagram
EMS
Monitoring
System
7.4
Option EMS (Enhanced Monitoring
System): Status LED / Error output
Flash light red
Error of signal sequence, zero pulse or
pulses
(Error output = HIGH-LOW change)
HIGH (5...30 V)
LOW (0 V)
Red
Overload output transistors
(Error output = LOW)
No light
No voltage supply connection or wrong
connection
(Error output = LOW)
HIGH (5...30 V)
LOW (0 V)
Flash light green
Device o.k., rotating
(Error output = HIGH)
Green
Device o.k., stopped
(Error output = HIGH)
HIGH (5...30 V)
LOW (0 V)
Err
Power
5...30 V
driver
0 V
Baumer_HOG11-R_II_DE-EN (20A1)
6)
MB072a - 11070667