Baumer Hubner Berlin microGen PMG10 EtherNet/IP 운영 매뉴얼 - 페이지 7

{카테고리_이름} Baumer Hubner Berlin microGen PMG10 EtherNet/IP에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer Hubner Berlin microGen PMG10 EtherNet/IP 40 페이지. Absolute encoder

페이지 인쇄

Baumer Hübner

General information

Intended use

This product is a precision device and serves the detection of items, objects, or physical mea-

surement variables and the preparation or provision of measured values as electric variables for

the higher-level system.

Unless specifically labeled, this product may not be used in explosive environments.

Commissioning

Assembly, installation, and calibration of this product may only be performed by a specialist.

Installation

Only use the fasteners and fastener accessories intended for this product for installation. Out-

puts not in use must not be wired. Unused wires of cable outputs must be insulated. Do not go

below the permissible cable bending radii. Disconnect the system from power before the prod-

uct is electrically connected. Use shielded cables to prevent electro-magnetic interference. If the

customer assembles plug connections on shielded cables, then EMC-version plug connections

should be used and the cable shield must be connected to the plug housing across a large sur-

face area.

Disposal (environmental protection)

V1 | PMG10 & PMG10P EtherNet/IP

Used electrical and electronic devices may not be disposed of in household

waste. The product contains valuable raw materials that can be recycled. There-

fore dispose of this product at the appropriate collection point. For additional in-

formation visit www.baumer.com.

Operating Manual

General information