Douglas Dynamics 77705 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Douglas Dynamics 77705에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Douglas Dynamics 77705 14 페이지. Light truck snowplow

4. Move the snowplow into an upright operating

position.

5. Reinstall the trip springs.

6. Adjust the trip springs by tightening the top nuts

until the coils of the springs begin to separate

(a piece of paper, such as this instruction sheet,

should pass between the second and third coils).

Remove the protective packaging from the angle

rams.

8. Align the holes in the rod end of the angle ram

with the corresponding holes on the back of the

quadrant.

9. Install a 1/2" x 3‑11/16" clevis pin from the top

down to attach each rod. Secure the clevis pins

with 5/32" x 1‑1/2" cotter pins from the parts bag.

Lit. No. 52524, Rev. 05

INSTALLATION INSTRUCTIONS

FINAL BLADE ASSEMBLY

1. Install a blade guide on each end of the blade as

shown.

5/16" x 1" Cap Screws

2. Install the supplied 1/2" x 1‑3/4" carriage bolts

and 1/2" locknuts in the two cutting edge holes

previously used for securing the blade to the

pallet.

Blade Guide

5/16" Locknuts

July 15, 2020