Douglas Dynamics 77750 설치 지침 매뉴얼 - 페이지 13
{카테고리_이름} Douglas Dynamics 77750에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Douglas Dynamics 77750 17 페이지. Snowplow
페이지 인쇄OPERATIONAL TEST AND FINAL ADJUSTMENTS
BLADE DROP SPEED ADJUSTMENT
WARNING
Keep 8' clear of the blade when it is being
raised, lowered, or angled. Do not stand
between vehicle and blade or directly in front
of the blade. If the blade hits or drops on you,
you could be seriously injured.
The quill in the valve manifold adjusts the blade drop
speed.
1. Lower the blade to the ground before making any
adjustment.
2. On the hydraulic unit, remove the cover.
3. Turn the quill IN (clockwise) to decrease drop
speed. Turn the quill OUT (counterclockwise) to
increase drop speed.
Quill
4. Stand 8 feet clear of the blade when checking
adjustment.
5. Replace the cover.
Lit. No. 52238, Rev. 05
FINAL INSPECTION AND ADJUSTMENT
Keep 8' clear of the blade when it is being
raised, lowered, or angled. Do not stand
between vehicle and blade or directly in front
of the blade. If the blade hits or drops on you,
you could be seriously injured.
1. Check that the trip springs are adjusted correctly
by confirming that the coils of the springs are
separated slightly.
Overtightening of the springs will increase
the blade trip force and cause damage to the
springs and snowplow assembly.
2. Adjust the trip springs by tightening the top nuts
until the coils of the springs begin to separate
(a piece of paper such as this instruction sheet
should pass between the second and third coils).
3. Fully angle the blade in both directions in raised
and lowered positions. Adjust hose fittings, wraps,
and clamps so that the hoses do not contact the
vehicle bumper and have no sharp bends. Hoses
should be wrapped at contact points with the
A‑frame, and must not become pinched between
the headgear and A‑frame.
4. Add grease to the two hitch pins and stand
actuator pin.
Use a good quality multipurpose grease.
13
WARNING
CAUTION
July 15, 2020