Baumer HUBNER BERLIN SAFETY POG 90 + ESL 90 설치 및 작동 지침 - 페이지 19
{카테고리_이름} Baumer HUBNER BERLIN SAFETY POG 90 + ESL 90에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer HUBNER BERLIN SAFETY POG 90 + ESL 90 32 페이지. Incremental encoder with integrated electronic speed switch
Baumer HUBNER BERLIN SAFETY POG 90 + ESL 90에 대해서도 마찬가지입니다: 설치 및 작동 지침 (32 페이지)
페이지 인쇄
6.1.6
Sensorkabel HEK 8 (Zubehör)
Es wird empfohlen, das Baumer Hübner
Sensorkabel HEK 8 zu verwenden oder
ersatzweise ein geschirmtes, paarig ver-
seiltes Kabel. Das Kabel sollte in einem
Stück und getrennt von Stromkabeln
verlegt werden.
Kabelabschluss:
HTL: 1...3 kΩ
TTL: 120 Ω
Rot/Red = +UB
Blau/Blue = 0V ( )
Weiß/White = K1
Braun/Brown = K1
Grün/Green = K2
Gelb/Yellow = K2
Grau/Grey = K0
Rosa/Pink = K0
Schwarz/Black = Err
Violett/Violet = 0V ( )
Option EMS
1)
MB068.2 - 11114905
1)
1)
Baumer_POG9-ESL_II_DE-EN (20A1)
Elektrischer Anschluss / Electrical connection
6.1.6
Sensor cable HEK 8 (accessory)
Baumer Hübner sensor cable HEK 8 is
recommended. As a substitute a shielded
twisted pair cable should be used.
Continuous wiring without any splices or
couplings should be used. Separate signal
cables from power cables.
Cable terminating resistance:
HTL: 1...3 kΩ
TTL: 120 Ω
Aderendhülsen benutzen.
Use core-end ferrules.
Kabelschirm
Cable shield
6
16