Douglas Dynamics SnowEx HDV 77870-1 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Douglas Dynamics SnowEx HDV 77870-1에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Douglas Dynamics SnowEx HDV 77870-1 16 페이지. Snowplow

T‑FRAME TO BLADE ASSEMBLY

1. Remove the blade wings from the crate. Remove

the four shipping straps, then replace the cutting

edge hardware.

2. Align the hinges of each wing. Position the

T‑frame assembly between the blade wings so

that the holes in the T‑frame are aligned with the

holes in wing hinges.

3. Insert the pivot pin from top to bottom through all

hinges as shown.

Lit. No. 52592, Rev. 04

INSTALLATION INSTRUCTIONS

1" x 4-3/4"

Clevis Pin

4. Move the snowplow into a normal operating

position.

5. Remove the protective packaging from the angle

rams.

6. Align the holes in the rod end of the angle ram

with the corresponding holes on the back of the

blade.

Install a 1" x 4‑3/4" clevis pin (from the shipping

bracket) from the top down to attach each rod.

Secure the clevis pins with 1/4" x 1‑1/2" cotter pins

from the parts bag.

Pivot Pin

1" x 4-3/4"

Clevis Pin

1/4" x 1-1/2"

Cotter Pins

July 15, 2020