Douglas Dynamics SnowEx Power Plow 8611 설치 지침 매뉴얼 - 페이지 11

{카테고리_이름} Douglas Dynamics SnowEx Power Plow 8611에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Douglas Dynamics SnowEx Power Plow 8611 17 페이지. Snowplow

페이지 인쇄

1. Hydraulic Unit

HEADLAMPS

WARNING

Your vehicle must be equipped with snowplow

headlamps and directional lights.

Headlamps, hardware, and instructions are found in

the headlamp box.

1. Install the vehicle wiring according to the

instructions provided.

2. Set the headlamp channel on the headgear, label

to the front, with the holes aligned.

3. With the correct headlamp on the correct side, set

each headlamp and swivel into place as shown.

4. Secure the headlamps with the correct hardware

for the application as shown. Inner and outer posts

require different hardware. On LED headlamps, a

rubber washer must be installed under the slotted

holes. Hand tighten.

5. Connect the headlamp wires to the headlamps.

6. Aim the headlamps according to the Snowplow

Headlamp Beam Aiming Instructions (Lit. No.

27769). For LED headlamps, tighten the fasteners

to 22 ft-lb (30 N·m). For halogen headlamps,

tighten the fasteners to 50 ft‑lb (68 N·m).

Halogen Headlamps

Lit. No. 52238, Rev. 05

INSTALLATION INSTRUCTIONS

Headlamp

Swivel

Headlamp

Channel

Lift Frame

1/2" Flat

Washers

1/2" Lock

Washers

1/2" Hex Nuts

From inside the headlamp channel, insert the

cable tie anchors into the holes as shown. The

anchor locking tabs should be horizontal.

Grommet

Cable

Ties

8. For halogen headlamps only, install a split rubber

grommet on each headlamp wire 3" from the

headlamp. Insert the grommet and wire into the

slot on the rear of the channel.

9. Route the wires under the channel and down the

back of the driver‑side vertical support. Secure the

wires to the anchors and the vertical support with

cable ties.

LED Headlamps

Cable Tie

Anchors

Run harness

underneath

channel.

Slotted

Hole

1/2" Rubber

Washer

July 15, 2020