Baumer Hubner POG 10 + FSL 설치 및 작동 지침 - 페이지 10

{카테고리_이름} Baumer Hubner POG 10 + FSL에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer Hubner POG 10 + FSL 36 페이지. Incremental encoder with integrated centrifugal switch
Baumer Hubner POG 10 + FSL에 대해서도 마찬가지입니다: 설치 및 작동 지침 (32 페이지)

페이지 인쇄
Baumer Hubner POG 10 + FSL 설치 및 작동 지침
4
Montage / Mounting
4

Montage

Montage mit EURO-Flansch B10 in Mon-
tageanleitung MB069.1T1.
4.1

Schritt 1

Anzugsmoment:
Tightening torque:
M
= 1 Nm
t
*
17
4.2

Schritt 2

* Siehe Seite 6
See page 6
Antriebswelle einfetten.
Die Antriebswelle sollte einen
möglichst kleinen Rundlauffehler
aufweisen, da dieser zu einem
Winkelfehler führen kann.
Rundlauffehler verursachen Vibrati-
onen, die die Lebensdauer des
Gerätes verkürzen können.
7
2.5 mm
Baumer_POG10-FSL-B3-T1_DE-EN_202209_MI_11068664 (22A1)
4

Mounting

EURO flange B10 mounting in mounting
instruction MB069.1T1.
4.1

Step 1

4.2

Step 2

Lubricate drive shaft.
The drive shaft should have as less
runout as possible because this can
otherwise result in an angle error.
Runouts can cause vibrations, which
can shorten the service life of the
device.
MB069a.1T1 - 11068664