Baumer PMG10P 운영 매뉴얼 - 페이지 12

{카테고리_이름} Baumer PMG10P에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer PMG10P 40 페이지. Absolute encoder
Baumer PMG10P에 대해서도 마찬가지입니다: 설치 및 작동 지침 (32 페이지), 설치 및 작동 지침 (36 페이지), 설치 및 작동 지침 (32 페이지), 운영 매뉴얼 (44 페이지), 운영 매뉴얼 (44 페이지), 운영 매뉴얼 (40 페이지), 운영 매뉴얼 (40 페이지), 운영 매뉴얼 (36 페이지)

Installation

Instruction:

a) Attach the coupling onto the encoder shaft according to the related mounting instructions.

b) When using the K 35 spring washer of Baumer Hübner, consider the maximum permitted

tolerances for mounting errors.

c) Fasten the coupling at the specified torque (K 35: Mt = 1 Nm (plastic side), Mt = 1.3 ± 10%

Nm (metal side)). Observe the remarks in the spring washer assembly instructions.

Also see about this

2 Maximum permitted tolerances for mounting errors when using the Baumer Hübner K 35

spring washer [} 17]

5.1.2

Mounting encoder onto drive shaft

DANGER

Injuries caused by shaft rotation

Hair and clothing may get caught in rotating shafts which may lead to serious personal injury.

a) Make sure the device is idle.

b) Before performing any work at the device, make sure power supply is and remains discon-

nected.

DANGER

Explosion

Sparks may cause fire or explosion.

a) Do not use the device in the near vicinity of explosive or highly flammable materials.

NOTICE

Equipment damage by mechanical overload

Mounting under tension may cause overload by constraining forces.

a) Observe the mounting instructions.

b) Observe the specified distances and/or angles.

NOTICE

Ball bearing damage caused by hard impacts on coupling

Hard shaft impacts imposed on parts of the coupling can damage the ball bearings and there-

fore are not permitted. If properly selected, the components can be easily assembled without

applying any axial pressure.

a) Otherwise, check and correct the dimensions and tolerances.

NOTICE

Severe runout errors of the drive shaft reduce service life and may cause angular errors.

Severe runout errors of the drive shaft cause vibrations that cut down on the encoder service

live and may cause angular errors.

a) Keep runout errors of drive shaft down to a minimum (recommended: ≤ 0.03 mm; maximum:

≤ 0.2 mm).

Operating Manual

Baumer Hübner

PMG10 & PMG10P EtherNet/IP | V1