Douglas Dynamics WESTERN ENFORCER 97540 설치 지침 매뉴얼 - 페이지 11

{카테고리_이름} Douglas Dynamics WESTERN ENFORCER 97540에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Douglas Dynamics WESTERN ENFORCER 97540 19 페이지. Ultramount 2 snowplow

페이지 인쇄

OPERATIONAL TEST AND FINAL ADJUSTMENTS

HYDRAULIC UNIT

WARNING

Keep 8' clear of the blade when it is being

raised, lowered, or angled. Do not stand

between the vehicle and blade or directly in

front of the blade. If the blade hits or drops on

you, you could be seriously injured.

The ENFORCER™ snowplow hydraulic system comes

from the factory pre-assembled, partially filled, and

fully tested.

1. Position the lift frame in the upright position with

the stand supporting the snowplow.

2. Place the driver‑side lift chain over the cable boot

bracket on the side of the upper lift frame.

Clevis

Washer

Hairpin

Cotter

3. Remove and retain the two hairpin cotters,

washers, and pins attaching the lift arm to the

lift frame.

NOTE: Support the lift arm after removing the pins

to prevent it from falling forward.

4. Pivot the lift arm and lift ram forward and remove

the hydraulic unit cover.

Lit. No. 74914, Rev. 01

5. Remove and discard the factory‑installed pipe

Lift

Arm

Place

lift chain

NOTE: Do not replace the hydraulic unit cover at

here.

this time.

6. Pivot the lift arm and lift ram up. Replace the two

8. Turn the control ON and completely retract the

plug from the top of the reservoir and install the

breather.

Breather

Pipe

Plug

Drain

Cap

pins, washers, and hairpin cotters to reattach the

lift arm to the lift frame.

Attach the snowplow to the vehicle according to

the instructions on the back of the blade.

WARNING

To prevent accidental movement of the blade,

always turn the control OFF whenever the

snowplow is not in use. The power indicator

light will turn OFF.

lift ram. Activate the control FLOAT function and

completely collapse the lift ram manually.

Fill

Plug

June 1, 2020