Douglas Dynamics SnowEx Brine Pro 2000 매뉴얼 - 페이지 5

{카테고리_이름} Douglas Dynamics SnowEx Brine Pro 2000에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Douglas Dynamics SnowEx Brine Pro 2000 10 페이지. Gas engine transfer pump, brine maker

페이지 인쇄

4. Insert the supplied 7/16" cap screw into the

impeller snout. As the cap screw is tightened, the

impeller will be pried off the shaft of the drive unit.

Remove the 7/16" cap screw once the impeller has

been removed from the drive unit.

5. If the pump impeller is to be reused, the ceramic

seal half (Item #6 on page 3) should be removed

from the impeller at this time. The impeller key

(Item #16 on page 3) that is located behind the

ceramic seal half should also be replaced at this

time.

6. Remove the four bracket screws, rear bracket

washers, and screw head O-rings from the rear

bracket using a 1/2" socket.

Intermediate

Shaft

Remove 4 bracket screws,

rear bracket washers, and

screw head O-rings.

Lit. No. 11814, Rev. 00

Using a round object such as a wrench socket, tap

gently with a hammer to remove the carbon seal

half from the rear bracket. The seal is very fragile;

take care not to crack the seal if it will be reused.

8. While the pump is completely disassembled, clean

all of the reusable parts thoroughly, removing any

traces of old gasket material and trapped or dried

liquids that were run through the pump.

With the four bracket screws removed, the rear

bracket and reservoir can now be removed from

the drive unit.

Rear Bracket

TPS-200

Reservoir

October 1, 2017