Baumer EXG03 사용자 설명서 - 페이지 7
{카테고리_이름} Baumer EXG03에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer EXG03 42 페이지. Gigabit ethernet
Baumer EXG03에 대해서도 마찬가지입니다: 사용자 설명서 (42 페이지)
페이지 인쇄
2.1.2.1.
Global Shutter
Global shutter means that all pixels of the sensor are reset and afterwards exposed for a
specified interval (t
exposure
For each pixel an adjacent storage area exists. Once the exposure time elapsed, the
information of a pixel is transferred immediately to its storage area and read out from
there.
Due to the fact that photosensitive surface get's "lost" by the implementation of the stor-
age area, the pixels mostly are equipped with microlenses, which focus the light to the
pixels active area.
2.1.2.2.
Rolling Shutter
Rolling shutter means that – in contrast to the global shutter – not the whole sensor is
exposed at once, but single portions successively. It is said the shutter "rolls" over the
sensor�
For Baumer EXG cameras with rolling shutter this means two pointers are "rolling" across
the sensor:
▪
First, the reset pointer deletes any information of former exposures stored within the
pixels (Frame
). After that the pixels are empty and restart collecting information
(n-1)
from incoming light – the new exposure (Frame
▪
Once a predefined interval – the exposure time t
pointer rolls across the sensor and the information of the pixels is read out.
▪
For example: On Baumer EXG50, the pass of a pointer lasts approx. 72 msec
(t
).
Full Frame
Due to technical issues of rolling shutter, a flash control depending on the
exposure time does not make sense. Such cameras should be used in a
continuously illuminated environment.
).
Pixel
Active Area (Photodiode)
Storage Area
Reset Pointer
Readout Pointer
Pixels of Frame
(n-1)
Currently exposed pixels (Frame
Read out pixels of current Frame (Frame
) begins.
(n)
– is elapsed, the readout
exposure
Microlens
◄ Figure 5
Structure of an imaging
sensor with global shut-
ter (interline).
– will be deleted
◄ Figure 6
)
(n)
Operating mode of a
)
rolling shutter.
(n)
7