Baumer EXG03c 사용자 설명서 - 페이지 28

{카테고리_이름} Baumer EXG03c에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer EXG03c 42 페이지. Gigabit ethernet
Baumer EXG03c에 대해서도 마찬가지입니다: 사용자 설명서 (42 페이지)

Figure 35 ▲

Operation of two camer-

as employing a Gigabit

Ethernet switch.

Data processing within

the switch is displayed

in the next two figures.

Figure 36 ►

Operation of two cam-

eras employing a

minimal inter packet

gap

(IPG).

Max. IPG:

On the Gigabit Ethernet

the max. IPG and the data

packet must not exceed 1

Gbit. Otherwise data pack-

ets can be lost.

Figure 37 ►

Operation of two camer-

as employing an optimal

inter packet gap (IPG).

5.3.1.

Example 1: Multi Camera Operation – Minimal IPG

Setting the IPG to minimum means every image is transfered at maximum speed. Even

by using a frame rate of 1 fps this results in full load on the network. Such "bursts" can

lead to an overload of several network components and a loss of packets. This can occur,

especially when using several cameras.

In the case of two cameras sending images at the same time, this would theoretically oc-

cur at a transfer rate of 2 Gbits/sec. The switch has to buffer this data and transfer it at a

speed of 1 Gbit/sec afterwards. Depending on the internal buffer of the switch, this oper-

ates without any problems up to n cameras (n ≥ 1). More cameras would lead to a loss of

packets. These lost packets can however be saved by employing an appropriate resend

mechanism, but this leads to additional load on the network components�

5.3.2.

Example 2: Multi Camera Operation – Optimal IPG

A better method is to increase the IPG to a size of

optimal IPG = packet size + 2 × minimal IPG

In this way both data packets can be transferred successively (zipper principle), and the

switch does not need to buffer the packets�