Baumer EXG50 사용자 설명서 - 페이지 18

{카테고리_이름} Baumer EXG50에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer EXG50 42 페이지. Gigabit ethernet
Baumer EXG50에 대해서도 마찬가지입니다: 사용자 설명서 (42 페이지)

페이지 인쇄
Baumer EXG50 사용자 설명서
Figure 17 ►
Partial Scan:
Parameters of the ROI.
18
On Baumer EXG cameras the correction factor γ is adjustable from 0.001 to 2.
The values of the calculated intensities are entered into the Look-Up-Table (see 4.1.4.). 
Thereby previously existing values within the LUT will be overwritten. 
Notice
If the LUT feature is disabled on the software side, the gamma correction feature also 
is disabled.
4.1.7 Partial Scan / Area of Interest (AOI)
With the "Partial Scan" function it is possible to predefine a so-called Area / Region of 
Interest (AOI / ROI). This ROI is an area of pixels of the sensor. On image acquisition, 
only the information of these pixels is sent to the PC. Therefore all the lines of the sensor 
need not be read out, which decreases the readout time (t
rate.
This function is employed, when only a region of the field of view is of interest. It is coupled 
to a reduction in resolution.
The ROI is specified by four values:
▪ Offset X  - x-coordinate of the first relevant pixel
▪ Offset Y  - y-coordinate of the first relevant pixel
▪ Size X 
- horizontal size of the ROI
▪ Size Y 
- vertical size of the ROI
). This increases the frame 
readout
Start ROI
End ROI