Baumer VeriSens ID Series 빠른 시작 매뉴얼 - 페이지 14

{카테고리_이름} Baumer VeriSens ID Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer VeriSens ID Series 44 페이지.

Creating a job in 4 steps

NOTE

For the XC series, the image

focus is set on the installed lens.

14 14 EN

Launch of VeriSens

Choose your device in the selection list. With

button, you connect with the selected VeriSens

sensor.

The display shows either Live images from the VeriSens

or Images from PC (example images). Select the image

source you require.

Use the Start image series button if no live image is

shown.

Adjusting an optimum image

To implement reliable inspection with the VeriSens

vision sensor, the features to be inspected must be clearly

visible.

Set the image focus with an inbus key on the

VeriSens

vision sensor installed at the testing site. The

corresponding inbus screw can be found on the sensor's

LED panel.

Check focus (device dependent):

Use the Focusing tab.

Set the trigger to

CONTINUOUS IMAGE CAPTURE

Use the option Automatically generate suggestion...

Enter the speed of the object and the distance to

object between the sensor and the object (see page 12,

Mechanical setup). The Application Suite calculates the

corresponding parameters automatically.

Manual fine adjustments of image brightness can be

made with the slider bar

image so that the object is seen to be bright enough

without the need to override.

Application Suite

EXPOSURE TIME

CONNECT

vision

. Adjust the