Dove Lighting Systems DimmerMaster 사용자 설명서 - 페이지 5
{카테고리_이름} Dove Lighting Systems DimmerMaster에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dove Lighting Systems DimmerMaster 12 페이지. Wall mount dimmer packs
페이지 인쇄Electrical Installation
The DM412-WM pack consists of four 1200W dimming channels, not to exceed 4800 Watts
total, and the DM124-WM has one 2400W dimming channel. They require a source of 120
Volts AC 50/60Hz with current capacity 40 or 20 Amps, respectively.
The actual amount of power consumed is determined by the total wattage of the connected
loads used; the dimmer itself consumes negligible power. It is recommended that no other
equipment be connected to the circuit which is used for the pack, including other outlets on
same fuse or circuit breaker. If the building circuit breaker trips, it may be necessary to
reduce one of the loads.
Line to neutral voltage is always 120 volts (unless the 240V version has been special
ordered). It is very important that the input voltage be checked with a meter to insure that it is
correct. A mistake can place 208 to 240 volts across a 120 volt lamp. The breaker will protect
the unit but may not save the lamp. A double check of voltages before applying power can
guard against such disaster.
The power input connector is a terminal block. The power feed connects to the terminal
marked "L." The neutral connection is made on the terminal to its left marked "N." The ground
connection is made on the ground terminal on the right end and labeled "G." The pack has
circuit breakers to protect each dimmer channel, but the primary circuit protection and
disconnect is to be provided by the user. A single pole 20 to 40 amp circuit breaker is
required.
When power is connected, the neon power indication lamp will light up (if so equipped). In
addition, the status LED will light up in red (60Hz line), yellow (50Hz line), and turn green
when a DMX signal is present.
DM412-WM Power Terminals
DM124-WM Power Terminals
WALL MOUNT SHOEBOX - USER MANUAL
5