Baumer FLDK 110G1005/S42 사용자 설명서 - 페이지 32

{카테고리_이름} Baumer FLDK 110G1005/S42에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer FLDK 110G1005/S42 35 페이지. Laser copy counter

Fault

Scatec counts less

copies than actually

pass the sensor

Manual SCATEC-2

Version 2021-09

Possible causes

a) Wrong sensitivity setting.

b) Copies too close to or too far away

from the Scatec, so that the copies

are in a distance range at which the

sensitivity of the sensor is inadequate.

c) Overlap spacing sporadically too

small.

d) Some copies are completely

covered by another copy.

e) Conveying speed too high.

f) False pulse suppression active

while overlap a is highly irregular or

conveying speed is occasionally

accelerated very quickly.

Corrective actions (see manual section x.x)

Set DIP-swich 4 off. (8; 9.3)

Set the distance of the copies in a range where

the sensor is sufficiently sensitive to detect the

copies. (10.6)

Increase the overlap spacing or reduce the

conveying speed (production rate). (9.1)

Prevent complete coverage of copies.

Reduce conveying speed. (10.6)

Deactivate false pulse suppression (DIP-switch 3

set off) or make overlap a more regular or

accelaerate slower (9.2)

www.baumer.com

Baumer Electric AG

Frauenfeld, Switzerland