Baumer FLDM 170C1030/S42 사용자 설명서 - 페이지 11
{카테고리_이름} Baumer FLDM 170C1030/S42에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer FLDM 170C1030/S42 44 페이지. Laser copy counter
페이지 인쇄
8.3 Beam blocker
Uncontrolled reflections of the laser beam can cause malfunctioning of the sensor or disturb people.
Therefore, a beam blocker should be fitted whenever possible to block the beam when there is no target
present. A beam blocker is a flat surface (at least 25mm x 25mm) made of any matte non-reflecting material.
It is mounted parallel to the sensor at any convenient distance.
The amber edge-LED must not light while the laser beam hits a beam blocker!
8.4 Retro-reflective foil (Part # FTDF 025F025)
Gaps in a lap stream can be clearly detected by a Scatec-10 / -15 if the retro-reflective foil (part number
FTDF 025F025, shipped with the sensor) is mounted as a beam blocker.
Certain false pulse suppression modes are based on a clear gap detection (for detailed explanation of these
modes, refer to section 9.2 Comments on the operational parameters.)
Correct mounting of the retro-reflective foil:
1.)
One side of the foil must be aligned parallel
line.
2.)
Scatec-10:
Mounting distance:
Tilt:
Scatec-15:
Mounting distance:
Tilt:
The amber edge-LED must light while the laser beam hits the retro-reflective foil!
User manual Scatec-10 / -15
Version 2017-10
70mm – 120mm away
from the sensor's lower
edge.
10° - 60° relative to the
conveying plane
100mm – 150mm away
from the sensor's lower
edge.
0° - 45° relative to the
conveying plane
11 / 44
www.baumer.com
to the laser
CORRECT
Scatec-10
47°
70 – 120 mm
Conveying plane
Retro-reflective foil
Scatec-15
61°
100 – 150 mm
Conveying plane
Retro-reflective foil
FALSE
Tilt :
10° - 60°
Tilt :
0° - 45°
Baumer Electric AG
Frauenfeld, Switzerland