Baumer NE216 사용 설명서 - 페이지 10

{카테고리_이름} Baumer NE216에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer NE216 22 페이지. Electronic preset counter

NE216
Example In the case of a length measurement by means of encoder and
32
Current count
After the counter has been turned on or upon selection via
appears for one second on the display. The current count is then
displayed for reading.
Read count PC.
Clear
Press
Preset P1
Read
Press
„P1" appears for one second on the display. The preset P1 is
then displayed for reading.
Modify
Enter preset P1 via
Press
Preset P2
Read
Press
„P2" appears for one second on the display. The preset P2 is
then displayed for reading.
Modify
Enter preset P2 via
Press
Start count SC
Read
Press
„SC" appears for one second on the display. The display then
jumps to the current start count SC.
Modify
Enter SC via
Press
Totalizer tot
Read
Press
„tot" appears for one second on the display. The display then
jumps to the current total.
If the value 99999 is exceeded, its display will be shown in two steps.
First step: Display of the first 5 digits.
Second step: marked by „H", Display of 6th, 7th and 8th digits.
Display of each value for approx. 3 seconds
Clear
Press
Scaling factor SF
The scaling factor allows the display of fractions or multiples of the
counting pulses.
Setting range: 0.0001 to 999.99
Setting ex factory: 1.0000.
cyclometer, where the circumference of the cyclometer measures
200 mm and the encoder supplies 500 pulses per revolution, the
measurement is to be displayed in mm.
The scaling factor is calculated as follows :
Scaling factor =
www.baumer.com
key.
key.
and
key.
key.
and
key.
key.
and
.
key.
key.
key.
Circumference
Pulses
.
.
200
=
= 0.4000
500
, „C"