Dover ALMATEC Quattroflow QF5050 Series 사용자 설명서 - 페이지 9
{카테고리_이름} Dover ALMATEC Quattroflow QF5050 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dover ALMATEC Quattroflow QF5050 Series 16 페이지. 4-piston diaphragm pump
페이지 인쇄
Version of April 2012
3.4 Start-Up
Prior to leaving our factory all pumps are subjected to a leakage and performance test. Only properly
operating pumps leave the factory achieving the performances assured by us. It is possible that there will be a
few milliliters of water inside the pump.
Prior to each use we recommend flushing the pump with a proper fluid (i.e. water or buffer)
Prior to the very first use it might make sense to clean and sanitize the pump chamber. A commercial caustic
cleaner and/or 0.5 to 1 mol of NaOH can be used. The chosen cleaning agent can be recirculated and also
stored inside the pump chamber.
For flushing out of any cleaning agent do not recirculate! Check with appropriate analytical methods the
success of the flushing procedure.
Recommendation: Test run prior first use!
Before using your pump in your process (for example as recirculation pump in a TFF
system) perform a test run to get used to the specific properties of the pump.
Please note:
ALMATEC Maschinenbau GmbH is also building custom-made pumps and set-ups. These modified pumps
can be different from this one that is described in here. However the basic information is applicable to all of
the Quattroflow QF5050 Series pumps.
Please do not hesitate to contact us for further information:
ALMATEC Maschinenbau GmbH
Carl-Friedrich-Gauss-Str. 5
D-47475 Kamp-Lintfort
Germany
Phone:
Fax:
e-mail:
Internet:
+49 2842 961-0
+49 2842 961-40
www.quattroflow.com
Page 9 of 16