Dover MOUVEX AX40 사용 설명서 - 페이지 12
{카테고리_이름} Dover MOUVEX AX40에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dover MOUVEX AX40 19 페이지.
페이지 인쇄
4. MAINTENANCE OPERATIONS (continued)
4.2 Re-assembling and disassembling the
wheel
Disassembly and reassembly of the wheel 3 are required
when :
- Replacing the shaft seal 26.
- Performing a complete overhaul.
- Disassembling or replacing the bearing box or the
reduction gear.
For disassemble the wheel 3, the pump hose must be
removed (see § REPLACING THE HOSE).
4.2.1 DISASSEMBLING THE WHEEL
1. Loosen screws 20a in the hub 20.
2. Tighten one of the screws 20a into the tapped hole of
the hub 20 provided to pull out the cone.
3. Remove the wheel 3 by sliding it along the central axis.
WARNING
BE CAREFUL WITH THE WEIGHT OF
THE PARTS WHEN THEY ARE BEING
REMOVED.
The weight ot the parts can
be dangerous and may
provoke bodily injuries or
material damages.
4.2.2 ASSEMBLING THE WHEEL
1. Check the shaft seal 26 and change it if necessary
(see § MAINTENANCE).
2. Assemble the shaft seal 26, the spring must be seen
inside the pump body 1.
3. Check the reduction gear shaft or the bearing box key
109 and change it if necessary.
4. Check that the shoes have no dents or deep scratches
that may quickly dereriorate the hose (see § REPLA-
CING THE SHOES).
5. Assemble the hub 20 in the wheel center.
6. Lightly tighten screws 20a.
Screws 20a must not be tightened so the wheel
assembly 3 can freely slide along the reduction gear
shaft or the gearing box shaft.
NT 1101-G00 08.10 AX40 - ASX40 e
NOTE
7. Slide wheel 3 on the reduction gear or the bearing box
shaft.
8. Align wheel 3 with pump body 1 while keeping setting
distance as indicated on the following diagram :
9. Gradually tighten screws 20a while keeping wheel
alignment correct.
4.3 Replacing the shoes
To replace the shoes 5, the pump hose must be disas-
sembled (see § REPLACING THE HOSE).
4.3.1 DISASSEMBLING THE SHOES
1. Partially untighten screw 28.
2. Remove the shims 4 from the shoe 5.
Some shims cannot be removed by sliding them
towards the outside. These special shims are installed
by the manufacturer and must be kept for reassembly.
These shims can be recognized as they have 2 holes
and have no notch like the other shims.
3. Completly loosen screw 28 and remove the washer 29.
4. Remove the shoe 5.
5. Remove the special shims 4.
12/19
Keying distance (L) :
80 ± 2 mm
(3,15 ± 0,079 in)
NOTES