Advanced MxPro 5 매뉴얼 - 페이지 5

{카테고리_이름} Advanced MxPro 5에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Advanced MxPro 5 10 페이지. Pager interface
Advanced MxPro 5에 대해서도 마찬가지입니다: 매뉴얼 (14 페이지), 애플리케이션 노트 (10 페이지)

페이지 인쇄
Advanced MxPro 5 매뉴얼

2.2 Cable Installation

Remove the existing ribbon cable between the display and the base card.
The supplied cable is provided with three connectors. Plug one connector into the display card and then plug
the second connector into the printer.
Route the cable through the clamp and plug into the connector on the base card (ensure that the heat shrink
protection is in place under the tabs on the base card chassis plate.
The cable is common to all panels. Route the cable up the side of the back box and fold up any excess and use
the clamp to hold in place.
CAUTION: Observe orientation (bumps) on the connectors when mating with the headers.
www.advancedco.com
Door release flap
Cable
clamp
Fixing
holes
To Base
Card
5