Amphenol Temposonics MH Series 사용자 설명서 - 페이지 7

{카테고리_이름} Amphenol Temposonics MH Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amphenol Temposonics MH Series 12 페이지. Analogue/pwm tester
Amphenol Temposonics MH Series에 대해서도 마찬가지입니다: 운영 매뉴얼 (18 페이지)

페이지 인쇄

2. Installation (continued)

2.3 Battery Charger

The M-Series tester will also run off AC power supplied by the charger included in the test kit. To run the box of AC power or to charge the battery plug the charger

barrel plug into the charger port on the top of the test box and connect the charger to an AC Outlet.

2.4 AC Power Plug Adapter Connection / Replacement

The kits battery charger can be used on both 110 Vdc and 230 Vdc systems. For this reason, additional AC power plug adapters can be purchased (see

Accessories).

Use the following steps to change the power plug adapter:

1. Unplug the AC adapter from the wall and from the M-Series Tester. Firmly hold the AC adapter in one hand with the plug facing you.

2. With the other hand, press down on the plug adapter and slide upwards away from you.

To replace the AC power plug adapter:

1. Chose the correct adapter.

2. Slide the adapter plug against the adapter (There are grooves along the

channel for the adapter plug). Slide the adapter down until it snaps into place

2.5 Quick Start Instruction Label

A quick start instruction label is included in the test kit. The label is designed to fit flush on the backside of the M-Series analogue/PWM Tester.

• Remove dust and dirt from the surface of the backside.

• Align and apply the label smoothly on the backside of the tester and apply the label smoothly.

+5V

GND

ANA

PWM

− − − −

+12V

Note:

There is an arrow on the adapter to denote the way to slide the plug during

removal.

M-Series Tester

User's Manual

MTS Sensors