Dover Triton 9600 전환 절차 - 페이지 7

{카테고리_이름} Dover Triton 9600에 대한 전환 절차을 온라인으로 검색하거나 PDF를 다운로드하세요. Dover Triton 9600 10 페이지.
Dover Triton 9600에 대해서도 마찬가지입니다: 전환 매뉴얼 (4 페이지)

10. Connect the EJ-to-Mech Dispenser Cable (09600-

00027) to the Electronic Journal. Route the cable

through the cable clips.

Connect EJ-to-Mech data cable to the

Electronic Journal.

Route EJ-to-Mech data cable through

cable clips.

RITON

YSTEMS

9640-

-9600

ONVERSION

ROCEDURE

INSTALL 9600 DISPENSER SLIDE TRAY

The SDD slide tray has three sets of holes: Top, Middle

and Bottom. Based on the dispenser type, you will use

either the Top or Middle holes to attach the slide

members, as indicated:

1. IMPORTANT: APPLY A SMALL AMOUNT OF

THREAD LOCK COMPOUND TO THE TIP OF EACH

SLIDE MOUNTING SCREW!

Attach an inner slide member (removed from the 9640

dispenser in a previous step) to the SDD dispenser

slide tray (03011-00434), using three included screws

(02054-00048) and nuts (02301-00040). DO NOT

TIGHTEN THE SCREWS AT THIS TIME! Repeat for

the other slide member.

•

TOP set of holes for older mechs.

MIDDLE set of holes for newer mechs.

For older-style mechs, attach slide

using TOP set of holes. For newer

mechs, use MIDDLE holes.

For older-style SDD dispensers, use the top set

of holes!

For newer-style SDD dispensers, use the middle

set of holes!