Comay Venus Pro series 사용자 설명서 - 페이지 3

{카테고리_이름} Comay Venus Pro series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Comay Venus Pro series 7 페이지.

Features

Backup Power Design *1

Comay Solid State Drive has an In-Drive UPS. The In-Drive UPS can keep working for four times

longer time than the SSD need to flush the cached data back to Nand Flash during any

unexpected host power spikes, dips or failures. It can greatly reduce the risk of data loss or even

become a dead "Brick".

Optimization Toolbox

There is a useful optimization toolbox along with Comay SSDs. It can easily help you to monitor

the key factors of your SSDs. More importantly, it can help to optimize both of hardware and

software settings, for instance, AHCI mode, disk partition alignment, to reach the performance

limit of the SSD can deliver.

*1. Not for some Series like Venus; for more detailed information, see your SSD's label.

Passed CR-E/CR-C Standardized Test*2

The Quality of Comay SSDs is fully guaranteed by CR-E or CR-C test. It is a extreme strict

standardized compound continues test, including a -40℃ to +85℃ test, a 10000 times

sleep-wake up test and a data burn-in test. It is much harder than common product and test

criterion. The standardized test can avoid mistakes made by human.

Overload Protection

SSDs always encounter unstable current due to variety of reasons such as power impulse, short

circuit, thunder, host power problems, hand touch, etc. With a sophisticated design, Comay SSDs

can switch off unstable power supply before damage is made to your SSDs. Since that, you can

keep both of your SSDs and your data safe.

*2. Test in Lab in the phase of R&D. Not every SSD needs to have such test. Meanwhile, the test is

destructive.

Installation

Congratulations on choosing a Comay Solid State Drive (SSD). The Comay SSD is ideal for use in

critical environment need for performance. The following instructions provide general installation

and handling information for your device or system.

Preparation before Use

Keep your Comay SSD away from direct sunlight, moisture and temperature extremes. Do not

bend, flex or drop your Comay SSD. Misuse will void the warranty.

Installation

1. Back up your data before installing.

2. Power off your system, disconnect the main power, such as power cord or battery.

3. Refer to the User's Manual of your system or device on how to remove the outer case and

where the SATA connectors are located on your motherboard.

4. Connect the SATA SSD to the SATA data cable and insert the SATA cable into the SATA connector

on the motherboard. Connect the SATA SSD to the SATA power connector.

5. SATA uses a point to point protocol; therefore, no setting of jumpers for master/slave

functionality is required.