Foldcraft Take-Out Order Shelf 설치 매뉴얼 - 페이지 3

{카테고리_이름} Foldcraft Take-Out Order Shelf에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Foldcraft Take-Out Order Shelf 3 페이지.

Order Express—Shelving

Assembly

Step 2: Assemble Frames

You should have 2 ladder frame ends and 3 stretchers. The

stretchers will have the 3/8‐16 x 2.5" Hex Head Cap Screw

threaded into them. Remove the hex head cap screws and

use them to assemble the frame.

b. A ach the stretchers to the ladder frames. You should have

2 at the top and 1 at the bo om back.

Step 4: Fasten Glides to the Floor

Rotate glides so that the moun ng hole is poin ng towards the center of the unit.

b. With a pencil, mark the hole loca on on the ﬂoor using the holes in the glide.

Turn the glide away 90 degrees from its current posi on to expose the mark on the ﬂoor.

d. Using a hammer drill and a 1/4" masonry bit, drill a 1 1/4" deep hole on the pencil mark.

e. Place a plas c anchor in the hole and then rotate glide back so its hole lines up with the

plas c anchor in the ﬂoor.

Insert a #10 x 1.00" screw through the hole in the glide and se‐

cure into the plas c anchor.

Note: Take‐Out Order Shelving must be anchored to the ﬂoor to

maintain stability and prevent personal injury.

Big gap to angles

at the bo om

Step 3: Add Shelves

Slide the top shelf into place. It should be ﬂush at the front and back and have

a slight gap on the ends. Using (6) #8 x 0.625" Phillips pan head screws fasten

the shelf into place. Repeat this for the other 3 shelves, working your way from

the top down to the bo om.

Page 3 of 3