Advanced Axis AX-PSU-6 설치 지침 - 페이지 2

{카테고리_이름} Advanced Axis AX-PSU-6에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Advanced Axis AX-PSU-6 2 페이지.

페이지 인쇄

These instructions cover the installation and replacement of the AX-PSU-6, Power Supply Charger Module.

Refer to separate wiring diagrams and manuals for additional system module installation wiring, operation and

programming functions.

AX-CTL-1:

Wiring Diagram: 670-1342

AX-CTL-1L, AX-CTL-2 and AX-CTL-4:

Wiring Diagram: 670-1233

AX-CTL-1V, AX-CTL-2V and AX-CTL-4V:

Wiring Diagram: 670-1233

AX-CC1-16, AX-CC2-16, AX-CC4-16 and Command Centers CCM-01/CCM-02:

Wiring Diagram: 670-1233

Caution: Before installing or removing any printed circuit boards remove all sources of power (AC and

battery).

ATTENTION

OBSERVE PRECAUTIONS

FOR HANDLING

ELECTROSTATIC

SENSITIVE DEVICES

Installation (see figure 1):

[1] Place the AX-PSU-6, Power Supply Charger Module, over the four (4) standoffs located on the right side of the

back box below the AX-CTL base card or below a previously installed AX-PSU, AX-PSU-6 and secure with the four (4)

provided screws.

[2] Connect the provided Molex connector cable into the available Molex connector on the AX-ACB, AC Board, and

wire the Hot, Neutral and Ground wires to the AC terminal block located on the AX-PSU-6 module.

[3] Wire AX-PSU-6 as indicated in figure 1, and in the product manuals.

Note: If there are no available Molex connectors on the AX-ACB, AC Board, remove the Molex connector on

the cable and wire directly to the AC input terminals of the AX-ACB, AC Board, or previous AX-PSU-6, Power

Supply Charger Module.

Replacement (see figure 1):

[1] Remove the AC, battery, 24 VDC output and relay trouble contact wiring from the AX-PSU-6, Power Supply

Charger, terminal block.

[2] Remove the four (4) screws securing the AX-PSU-6, Power Supply Charger Module, to the back box and remove

the AX-PSU-6 module.

Doc Number:

682-028 AFS

Revision:

First Issued:

2013-mm-dd

Product Manual: 682-010

Product Manual: 682-001

Product Manual: 682-001V

Product Manual: 682-001CC

This equipment is constructed with static sensitive components. Observe anti-static precautions

at all times when handling printed circuit boards. Wear an anti-static ground strap connected to

panel enclosure earth ground.

Program Manual: 682-002

100 South Street, Hopkinton, Massachusetts 01748

Tel:

(508) 435-9995

Fax:

Email:

[email protected]

Web:

www.advancedco.com

(508) 435-9990