Amphion FlexBase25 참조 매뉴얼 - 페이지 6
{카테고리_이름} Amphion FlexBase25에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Amphion FlexBase25 12 페이지.
페이지 인쇄Back panel connections
6
.
6
Input +4dB (L and R)
These are the balanced inputs for your stereo signal. If you are using an unbalanced source, it is
recommended to connect XLR pin 3 to pin 1.
7
Main out (L and R)
These are the outputs for your main power amp and speakers. If you are using an unbalanced destination,
it is recommended to leave XLR pin 3 unconnected.
8
LFE input
This is a direct input for a separate LFE signal (such as the .1 in a 5.1 monitoring setup). Sensitivity is +10dB
compared to the main inputs, and there is no built-in low pass filtering applied. In other words, the crossover
frequency does not affect this signal. The LFE level is also not affected by the front panel level setting.
9
LFE link out
This connector is provided for chaining the LFE signal across several BaseAmp units (typically in a multichannel
setup).
10
Base out
Neutrik Speakon (NL4FX) 4-pole speaker output for the FlexBase25 tower.
11
IEC power connector
Power input, auto switching in the 100-240V range, internally fused.
7
8
9
6
10
11