Amphony 1000 사용자 및 설치 설명서 - 페이지 4

{카테고리_이름} Amphony 1000에 대한 사용자 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amphony 1000 8 페이지. 2.4 ghz digital wireless headphones
Amphony 1000에 대해서도 마찬가지입니다: 기능 비교 (1 페이지), 제품 정보 (4 페이지), 자주 묻는 질문 (4 페이지)

페이지 인쇄

User and Installation Guide

Step 3

Installing the headphone batteries

Two AA (UM-3, R6, Mignon - 1.5 V) batteries are required to operate the

headphones. Rechargable batteries with a sufficiently high voltage can be used

as well. Choosing batteries with a high capacity (mAh) will extend operating time.

There are two battery compartments, located on both sides, each housing one

battery. To access each battery compartment, push on the outer edge of the

battery lid. This will release the battery lid. Then lift the middle portion of the

battery lid to gain access to the battery compartment.

Insert the battery by pressing the minus pole of the battery against the spring at

the bottom of the battery compartment until the plus pole can slide into the battery

compartment. The battery should snap into place.

Be sure to only use batteries with a well formed plus pole to ensure proper

contact between the plus pole of the battery and the plus pole inside the battery

compartment and also to ensure that the battery will not slide out of the battery

compartment unintentionally.

Finally, close the battery lid by pushing the middle section. It should snap into the

closed position.

To replace the batteries, open the battery lid as described above and pull the

battery out of the battery compartment by pushing the battery towards the bottom

until the plus pole is released and slides out.

Never leave batteries inside the headphones for very long periods

ATTENTION!

of time to prevent any damage to the headphones from leaking

batteries. Dispose of spent batteries conforming to local waste

disposal rules.

Push

Lift

Page 3