Amphony 500 사용자 및 설치 설명서 - 페이지 5

{카테고리_이름} Amphony 500에 대한 사용자 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amphony 500 8 페이지. 5.8 ghz digital wireless headphones

User and Installation Guide

Step 4

Operating the headphones

After powering up the transmitter, the transmit light will light for approximately

5 seconds while the transmitter initializes.

After initialization, the transmit light will go out.

Once audio is detected at the audio input, the transmit light will light and the

transmitter will transmit the audio signal.

Set the volume control of the headphones to minimum. Then, switch on the

headphones and slowly increase volume.

After each use, be sure to switch off the headphones to extend battery life.

When no audio is present anymore, the transmitter will go into standby mode

after approximately 1 minute. The transmit light will go out. During standby

mode, no signal is transmitted. If the headphones are not used for an

extended period of time, remove the AC adapter from the power outlet.

Listening over headphones at high audio levels can cause

ATTENTION!

hearing impairments! Also, switching between different audio

sources, connecting and disconnecting the transmitter, and

the transmitter going into standby mode can cause loud clicks

and pops which can impair your hearing! Therefore, always set

the volume control to minimum.

Transmit light

R R

5.8 GHz Digital Audio Transmitter

R R

Page 4