Amphony 1520 사용자 및 설치 설명서 - 페이지 12
{카테고리_이름} Amphony 1520에 대한 사용자 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amphony 1520 20 페이지. 5.8 ghz digital wireless audio transmitter / amplifier
Amphony 1520에 대해서도 마찬가지입니다: 문제 해결 매뉴얼 (4 페이지), 기술 사양 (2 페이지), 기능 비교 (1 페이지), 사양 (4 페이지), 자주 묻는 질문 (5 페이지), 제품 정보 (4 페이지), 제품 정보 (4 페이지)
페이지 인쇄
User and Installation Guide
Step 5
Step 5
Operating the amplifier
As soon as a valid transmitter signal is received by the amplifier, the amplifier
will output the amplified audio signal to the speaker outputs. You can change
the audio level by adjusting the amplifier volume control.
In order to achieve maximum transmission quality, the transmitter volume
control should be set to match the audio level of your audio source as follows:
1) Set the amplifier volume control to a low level to prevent clipping inside the
amplifier.
2) Set your audio source to output the maximum audio level that you will
encounter during normal operation.
3) Turn the transmitter level control knob to the position that yields maximum
audio loudness to the speakers without any clipping (distortion). If the
transmitter level is set too low, the dynamics of the transmission are not
fully used. If the level is set too high, audio clipping (distortion) will occur
inside the transmitter.
4) Turn the amplifier volume control to a setting that yields the desired volume
from the speakers.
If no audio signal is received for more than 2 minutes, the amplifier will go into
standby mode (power-down mode).
Amplifier
volume
control
R R
Page 11