Dovre 500cc 설치 및 운영 매뉴얼 - 페이지 3

{카테고리_이름} Dovre 500cc에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dovre 500cc 19 페이지.

페이지 인쇄

-1-

SECTION'

PLANNING INSTALLATION

PLANNING YOUR STOVE INSTALLATION WILL HELP MAKE THE JOB GO SMOOTHLY AND SAFELY. WHILE

YOUR DOVRE APPLIANCE IS LISTED BY UL AND ULC, IT IS STILL IMPORTANT TO CHECK LOCAL AND

STATE BUILDING CODES BEFORE BEGINNING THE INSTALLATION. YOU MAY BE REQUIRED TO OBTAIN A

BUILDING PERMIT IN SOME AREAS. THIS CAN BE ACCOMPLISHED BY CONTACTING YOUR BUILDING

INSPECTOR.

IN ADDITION, WE RECOMMEND THAT YOU NOTIFY YOUR INSURANCE COMPANY REPRESENTATIVE AS

SOME HOMEOWNER'S INSURANCE COMPANIES REQUIRE AN INSPECTION OF YOUR INSTALLATION. THIS

CAN GIVE YOU THE ADDED

SAFETY OF AN OUTSIDE

OPINION

OF THE INSTALLATION.

FINDING THE RIGHT LOCATION FOR YOUR STOVE IS A BIG PART OF THE PLANNING PROCESS. YOUR

STOVE IS A RADIANT ROOM HEATER AND DEPENDS ON GOOD AIR CIRCULATION TO MOVE THE HEAT

GENERATED. THEREFORE, A CENTRAL LOCATION IS BEST IF YOU ARE DEPENDING ON YOUR STOVE AS

THE PRIMARY HEAT SOURCE. IF YOUR STOVE IS TO BE A ZONE OR SECONDARY HEAT SOURCE, CONSIDER

PLACING IT IN A HARD- TO -HEAT AREA OR IN THE MAIN LIVING AREA. OF COURSE, IF YOU ARE GOING

TO USE AN EXISTING CHIMNEY, YOU MAY HAVE TO COMPROMISE SOMEWHAT ON THE LOCATION. IF THIS

IS GOING TO CAUSE TOOMUCH OF A PROBLEM, YOU MAY ELECT TO CONSTRUCT A NEW FACTORY-BUlL T

CHIMNEY INSTEAD. SEE THE SECTIONS ON WALL AND FLOOR PROTECTION ON PAGE 7 AND PAGE 8.

THE DOVRE HORIZON IS NOT APPROVED FOR INSTALLATION IN MOBILE HOMES.

OTHER RECCMMENDED READING FOR SOLID FUEL USERS ARE:

I. VIVIAN, WOOD HEAT

RODALE PRESS, 1976

ISBN 0-87857-149-3

PAPERBACK

2. SHELTON

SHAPIRO, THE WooDBURNER'S ENCYCLOPEDIA

VERMONT CROSSROADS PRESS, 1977

ISBN 0-915248-08-5

PAPERBACK

3. SHELTON, SOLID FUELS ENCYCLOPEDIA

GARDEN WAY PUBLISHING, 1983

ISBN 0-88266-307-0

PAPERBACK

ASSEMBLY

SINCE A CAST IRON HEATER IS HEAVY, IT IS EASIER TO ASSEMBLE AND INSTALL WITH TWO PEOPLE.

BEFORE STARTING ASSEMBLY, PLACE THE UNIT NEAR THE FINAL POSITION, THEN FOLLOW THE

PROCEDURE BELOW:

I. OPEN THE STOVE AND REMOVE ALL PARTS AND ARTICLES PACKED INSIDE. OPEN THE BOX

FOUND IN THE UNIT, CHECK THE PARTS LIST AND INSPECT ALL PARTS AND THE CAST IRON

BODY FOR SHIPPING DAMAGE.

CONTACT YOUR DEALER IF ANY IRREGULARITIES ARE

NOTICED. YOU SHOULD ALSO REMOVE THE GLASS DOOR, THE SIDE LOADING DOOR, GRATES,

LOO RETAINER, SIDE

BACK BURN PLATES AND ASH PAN TO MAKE THE UNIT LIGHTER AND

EASIER TO MANUVER.