Amphony 1600 사용자 및 설치 설명서 - 페이지 9
{카테고리_이름} Amphony 1600에 대한 사용자 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amphony 1600 13 페이지. 5.8 ghz digital wireless speaker kit
페이지 인쇄User and Installation Guide
Troubleshooting
Proble m
Possible Cause
The transmit light
Faulty AC adapter
do es not go on after
or faulty power outlet
DC power is applied
to the transmitter
The transmit light
No audio present at
go es out after a few
audio input
seco nds and does
no t li ght again
Tran smitter hung up
No a udio at
Faulty AC adapter
amplifie r
or faulty power outlet
Tran smitter volume
control set too low
Amplifier volume
control set too low
Strong interference
Aud io is distorted
Tran smitter volume
control set too high
Amplifier volume
control set too high
Strong interference
Spe aker audio level
Tran smitter volume
is too lo w
control set too low
Amplifier volume
control set too low
Audio signal too
weak
Page 8
R
Solution
Check the power outlet and
the AC adapter; if possible,
check for correct voltage of
the AC adapter.
Check the audio connection
to the transmitter and ensure
that there is audio present.
Disconnect and then
reconnect DC power.
See under "Faulty AC adapter
or faulty power outlet" above.
Adjust the transmitter volume
control.
Adjust the amplifier volume
control.
See under "Strong
Interference" on next page.
Adjust the transmitter volume
control until clipping stops.
Adjust the amplifier volume
control until clipping stops.
See under "Strong
Interference" on next page.
Adjust the transmitter volume
control to achieve desired
audio level.
Adjust the amplifier volume
control to achieve desired
audio level.
Increase the output level of
the audio source (connect
transmitter to an adjustable
output by using an adapter if
necessary).
Guide d'Utilisateur et d'Installation
Fonctionnement du transmetteur
4ème étape
Après avoir branché le transmetteur, la lumière de transmission s'allume pour
environ cinq secondes durant l'initialisation.
Après l'initialisation, la lumière s'éteint.
Au début, réduisez le volume au mi-niveau.
Lorsque l'audio est détectée par le transmetteur, la lumière de transmission
s'allume et transmet le signal audio.
Lorsque l'audio n'est plus présente, le transmetteur entrera dans le mode
repos après environ une minute et la lumière s'éteindra. Durant le mode
repos, il n'y a pas de signal transmis.
Lumière de transmission
R
Contrôle de volume du transmetteur
L
R
5.8 GHz Digital Audio Transmitter
R
DC 9V
L
R
Page 17
100
95
75
25
5
0